Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE PARKING BRAKE ASSEMBLY
  1. Remove the parking brake assembly (Click here).



3. REMOVE REAR AXLE HUB BOLT LH


    G020975E02
  1. Using SST and a screwdriver or equivalent to hold the axle hub, remove the hub bolt.

    SST
    09650-17011  
    Text in Illustration 
    *1
    Nut
    *a
    Turn
    *b
    Hold

    NOTICE:
    1. Do not deform the oil deflector.
    2. Make sure to align the notch of SST with the flange of the oil deflector.



4. INSTALL REAR AXLE HUB BOLT LH


G020976E01
  1. Insert a new hub bolt.

  1. Temporarily install a washer and hub nut to the hub bolt as shown in the illustration.
    Text in Illustration 
    *1
    Washer
    *2
    Nut
    *a
    Turn
    *b
    Hold

    NOTICE:
    Install a hub nut to prevent damage to the hub bolt.

  1. Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.

  1. Remove the hub nut and washer.

    NOTICE:
    Do not damage the threads of the hub bolt.



5. INSTALL PARKING BRAKE ASSEMBLY
  1. Install the parking brake assembly (Click here).



6. INSTALL REAR WHEEL

Torque:
112 N*m{ 1137 kgf*cm , 82 ft.*lbf }