Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR

COMPRESSOR > REMOVAL

for Preparation Click here



1. REMOVE GENERATOR ASSEMBLY
  1. Remove the generator assembly (Click here).



2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



3. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    E199372
  1. Remove the bolt and disconnect the discharge hose from the cooler compressor.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



4. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    E199373
  1. Remove the 2 bolts and disconnect the suction hose from the cooler compressor.

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



5. REMOVE COOLER COMPRESSOR ASSEMBLY


    E195719
  1. Disconnect the connector.

  1. Remove the 3 bolts and nut.

  1. Remove the stud bolt and cooler compressor.