Home › Power Source / Network › 1GR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL


3. REMOVE BATTERY CLAMP


    A223416
  1. Loosen the 2 nuts and remove the battery clamp.



4. REMOVE BATTERY


5. REMOVE BATTERY TRAY


6. REMOVE V-BANK COVER


    A229925E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then detach the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    V-bank Cover Hook



7. REMOVE FAN AND GENERATOR V BELT


    A217571
  1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.



8. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY


    A223415
  1. for Integrated Type:
    Remove the bolt and No. 2 idler pulley.

  1. for Separate Type:
    Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley and idler pulley cover plate.



9. REMOVE WIRING HARNESS CLAMP BRACKET


    A222903
  1. Detach the clamp.

  1. Remove the bolt and wiring harness clamp bracket.



10. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A289304
  1. Remove the 3 bolts and No. 2 exhaust manifold heat insulator.



11. REMOVE GENERATOR ASSEMBLY


    A222881
  1. Open the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the generator connector from the generator assembly.



    A222884
  1. Remove the 2 bolts and disconnect the wire harness.



    A222882
  1. Disconnect the wire harness clamp.

  1. Remove the bolt and disconnect the generator bracket.



    A222883
  1. Remove the 2 bolts and generator assembly.



    A222885
  1. Remove the bolt and generator bracket.