QUARTER WINDOW GLASS > REMOVAL |
| 1. REMOVE ROOF HEADLINING ASSEMBLY |
| 2. REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY LH |
![]() |
Detach the 3 clips.
Cut off the 3 clips to remove the roof side rail garnish assembly LH.
Remove 3 clips from the vehicle body.
| *1 | Clip |
| 3. DISCONNECT WINDOW GLASS ANTENNA WIRE |
![]() |
Disconnect the window glass antenna wire connector (for LH side).
![]() |
Disconnect the window glass antenna wire connector (for RH side).
| 4. REMOVE REAR QUARTER WINDOW ASSEMBLY LH |
![]() |
From the interior, insert a piano wire between the vehicle body and rear quarter window assembly LH as shown in the illustration.
| *1 | Protective Tape |
| *2 | Piano Wire |
![]() |
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut through the adhesive by pulling the piano wire around the rear quarter window assembly LH.
Using suction cups, remove the rear quarter window assembly LH.
| 5. REMOVE REAR QUARTER WINDOW ASSEMBLY RH |
| 6. CLEAN VEHICLE BODY |
![]() |
Clean and shape the contact surface of the vehicle body.
| *1 | Adhesive |
| *2 | Vehicle Body |
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Clean the contact surface of the vehicle body with cleaner.