DTC C1256 Accumulator Low Pressure |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1256 | The fluid pressure inside the accumulator is below the standard value. |
|
| 1.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Depress the brake pedal 20 times or more.
Turn the ignition switch to ON.
Wait for 99 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 2.INSPECT HYDRAULIC BRAKE BOOSTER ASSEMBLY FUNCTION |
Inspect brake booster pump power supply system function.
Turn the ignition switch off.
Depress the brake pedal 20 times or more to release the pressure in the accumulator.
Check that the brake fluid level is at the MAX level.
Chock the 4 wheels and release the parking brake.
Turn the ignition switch to ON and measure the brake booster pump operating time (the time from when the brake booster pump starts operating until it stops).
Start the engine after the brake boost pump stops.
Check that the ABS warning light and slip indicator light are not illuminated.
Turn off the engine, and then turn the ignition switch to ON.
Check that the brake boost pump operates and then stops when the brake pedal is depressed 4 or 5 times.
Depress the brake pedal 4 or 5 times and measure the brake booster pump operating time (the time from when the brake booster pump starts operating until it stops).
Check that the brake warning light illuminates and the buzzer sounds when the brake pedal is fully depressed continuously 15 to 20 times.
Check brake booster operation.
Turn the ignition switch off.
Depress the brake pedal 20 times or more to release the pressure in the accumulator.
Depress the brake pedal, start the engine, and check the change in the brake pedal height.
Inspect brake master cylinder fluid pressure change .
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (ACCUMULATOR SENSOR) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Accumulator Sensor | Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V | 3.58 to 5 V | If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected. |
Check that the accumulator output value is normal.
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||
| 5.INSPECT BRAKE BOOSTER PUMP ASSEMBLY |
Remove the hydraulic brake booster assembly (Click here).
Using a screwdriver, remove the 2 screws and pull out the wire harness from the master cylinder solenoid.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Red wire terminal - Black wire terminal | Always | Below 2 Ω |
| *1 | Pump motor wire harness |
| *a | Red wire |
| *b | Black wire |
Install the pump motor wire harness to the master cylinder solenoid with the 2 screws.
|
| ||||
| OK | ||
| ||