Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C0226    SFR Solenoid Circuit

DTC    C0236    SFL Solenoid Circuit

DTC    C0246    SRR Solenoid Circuit

DTC    C0256    SRL Solenoid Circuit

DTC    C1225    SM Solenoid Circuit

DTC    C1226    SA2 Solenoid Circuit

DTC    C1227    SA3 Solenoid Circuit

DTC    C1228    STR Solenoid Circuit

for Preparation Click here


DESCRIPTION

The solenoid turns on when signals are received from the skid control ECU and controls the pressure acting on the wheel cylinders, thus controlling braking force.

DTC Code
DTC Detection Condition
Trouble Area
C0226
An open or short circuit in the SFRH or SFRR circuit continues for 0.05 seconds or more.
  1. SFRH or SFRR circuit
  2. Master cylinder solenoid
C0236
An open or short circuit in the SFLH or SFLR circuit continues for 0.05 seconds or more.
  1. SFLH or SFLR circuit
  2. Master cylinder solenoid
C0246
An open or short circuit in the SRRH or SRRR circuit continues for 0.05 seconds or more.
  1. SRRH or SRRR circuit
  2. Master cylinder solenoid
C0256
An open or short circuit in the SRLH or SRLR circuit continues for 0.05 seconds or more.
  1. SRLH or SRLR circuit
  2. Master cylinder solenoid
C1225
An open or short circuit in the SMCF circuit continues for 0.05 seconds or more.
  1. SMCF circuit
  2. Master cylinder solenoid
C1226
An open or short circuit in the SREA circuit continues for 0.05 seconds or more.
  1. SREA circuit
  2. Master cylinder solenoid
C1227
An open or short circuit in the SREC circuit continues for 0.05 seconds or more.
  1. SREC circuit
  2. Master cylinder solenoid
C1228
An open or short circuit in the STR circuit continues for 0.05 seconds or more.
  1. STR circuit
  2. Master cylinder solenoid

WIRING DIAGRAM


C219140E01


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.RECONFIRM DTC

HINT:
These codes are stored when a problem is detected in the master cylinder solenoid.
The solenoid circuit is in the master cylinder solenoid.
Therefore, solenoid circuit inspections and solenoid unit inspections cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

  1. Clear the DTCs (Click here).

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)