DTC C1254 Pressure Sensor or Switch |

| DTC Code | DTC Detection Condition | Trouble Area |
| C1254 | There is an accumulator pressure sensor malfunction (the fluid pressure does not change when the pump operates or when the brake is applied). | Master cylinder solenoid (Accumulator pressure sensor) |
| 1.READ VALUE USING TECHSTREAM (ACCUMULATOR SENSOR) |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Accumulator Sensor | Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V | 3.58 to 5 V | If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected. |
Check the accumulator output value.
| Result | Proceed to |
| Output value is within "Normal Condition" range | A |
| Output value is out of "Normal Condition" range | B |
| Output value is constant regardless of pump operation |
|
| ||||
| A | |
| 2.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Wait until the pump motor stops.
Wait for 15 minutes.
Depress the brake pedal and release it.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||