Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1257    Power Supply Drive Circuit

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.

DTC Code
DTC Detection Condition
Trouble Area
C1257
There is an open in the motor system circuit (motor input circuit).
Master cylinder solenoid (Skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).

1.CHECK PUMP MOTOR OPERATION
  1. Turn the ignition switch off.

  1. Disconnect the A6 skid control ECU connector.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Check pump motor operation.

    OK:
    Pump motor operates normally.



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK


2.RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Reconnect the A6 skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)