REAR NO. 2 SEAT OUTER BELT ASSEMBLY > REMOVAL |
| 1. REMOVE REAR NO. 2 SEAT ASSEMBLY |
Remove the rear No. 2 seat assembly (Click here).
| 2. REMOVE REAR NO. 1 FLOOR STEP COVER |
![]() |
Using a screwdriver, detach the 2 claws to remove the rear No. 1 floor step cover.
| *1 | Protective Tape |
| 3. REMOVE QUARTER SCUFF PLATE LH |
![]() |
Remove the 2 bolts and quarter scuff plate LH.
| 4. REMOVE REAR DOOR SCUFF PLATE LH |
Put protective tape around the rear door scuff plate LH.
![]() |
Using a screwdriver, detach the 3 clips, 6 claws and 2 guides to remove the rear door scuff plate LH.
| *1 | Protective Tape |
| 5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Remove the rear door opening trim weatherstrip LH.
| 6. REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER |
![]() |
Detach the 3 claws to remove the rear No. 1 seat outer lap belt anchor cover.
| 7. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
![]() |
Remove the No. 1 luggage compartment trim hook by turning it clockwise.
| 8. REMOVE FRONT DECK SIDE TRIM COVER LH |
![]() |
Using a screwdriver, detach the 2 claws to remove the front deck side trim cover LH.
| *1 | Protective Tape |
| 9. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH |
![]() |
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
![]() |
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
![]() |
for RH Side:
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 7 clips, 5 claws and 2 guides and remove the deck trim side panel.

| 10. REMOVE REAR NO. 2 WINDOW SIDE GARNISH ASSEMBLY LH |
![]() |
w/o Rear No. 2 Seat:
Detach the 6 clips and guide to remove the rear No. 2 window side garnish assembly LH.
![]() |
w/ Rear No. 2 Seat:
Detach the 6 clips and guide.
![]() |
Detach the 7 claws and guide and pass the rear No. 2 seat outer belt floor anchor through the rear No. 2 window side garnish assembly LH to remove the rear No. 2 window side garnish assembly LH.
| 11. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY LH |
![]() |
Detach the 7 clips and 4 guides.
![]() |
Detach the 4 claws and 2 guides and pass the rear No. 1 seat outer belt floor anchor through the rear window side garnish assembly LH to remove the rear window side garnish assembly LH.
| 12. REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH |
![]() |
Remove the bolt and rear No. 2 seat outer belt shoulder anchor.
![]() |
Remove the 2 bolts and rear No. 2 seat outer belt assembly.
| 13. REMOVE REAR SEAT OUTER BELT ANCHOR PLATE SUB-ASSEMBLY LH |
![]() |
Remove the bolt and anchor plate.
| 14. REMOVE SEAT BELT ANCHOR PLATE ASSEMBLY |
![]() |
Remove the 2 bolts and anchor plate.