Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Interior Light Auto Cut Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) controls operation of the DOME relay in order to supply power to the interior lights. When battery saving control operates while the interior lights are on, the main body ECU (multiplex network body ECU) opens the DOME relay to turn off the lights.

WIRING DIAGRAM


E261239E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK SYMPTOMS
  1. Check symptoms.

    Result 
    Result
    Proceed to
    All the interior lights that receive power via the DOME relay do not illuminate.
    A
    Battery saving function does not operate.
    B



B
Go to step 4
A


2.INSPECT DOME RELAY
  1. Remove the DOME relay from the engine room relay block, junction block.

  1. Inspect the DOME relay (Click here).



NG
REPLACE DOME RELAY
OK


3.CHECK HARNESS AND CONNECTOR (DOME FUSE - DOME RELAY)


    B242123E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    DOME relay terminal 5 - Body ground
    Ignition switch off
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to DOME Relay)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Using the Techstream, perform the Active Test (Click here).

    HINT:
    In the Active Test, check the interior light operating state.


    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Relay for Interior Light Auto Cut Function
    DOME relay
    ON/OFF
    -

    OK:
    Battery saving control operates.

    HINT:
    1. In the Active Test, selecting the DOME relay ON or OFF turns the interior light on or off.
    2. After turning the ignition switch to ON, proceed to the preceding screen of the active test screen with the Techstream and turn the ignition switch off, and perform the active test.



NG
Go to step 5
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

5.INSPECT DOME RELAY
  1. Remove the DOME relay from the engine room relay block, junction block.

  1. Inspect the DOME relay (Click here ).



NG
REPLACE DOME RELAY
OK


6.CHECK HARNESS AND CONNECTOR (DOME RELAY - MAIN BODY ECU, BODY GROUND)
  1. Remove the Main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    DOME relay terminal 2 - F9-2 (DOMR)
    Always
    Below 1 Ω
    DOME relay terminal 1 - Body ground
    Always
    Below 1 Ω
    F9-2 (DOMR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)