Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

KINETIC DYNAMIC SUSPENSION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.

      NEXT


      4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
      1. Inspect the CAN communication function to make sure there are no malfunctions in the communication system (Click here).
        Result 
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B



      B.
      GO TO CAN COMMUNICATION SYSTEM
      A


      5.CHECK AND CLEAR DTC
      1. Check for DTCs (Click here).


      NEXT


      6.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to step 9
      A


      7.SYMPTOM SIMULATION

        NEXT


        8.CHECK DTC*
        1. Check for DTCs (Click here).
          Result 
          Result
          Proceed to
          DTC not output
          A
          DTC output
          B



        B.
        Go to step 10
        A


        9.PROBLEM SYMPTOMS TABLE
        1. Refer to the Problem Symptoms Table (Click here).


        NEXT

        Go to step 12


        10.DTC CHART
        1. Refer to the Diagnostic Trouble Code Chart (Click here).


        NEXT


        11.CIRCUIT INSPECTION

          NEXT


          12.IDENTIFICATION OF PROBLEM

            NEXT


            13.REPAIR OR REPLACE

              NEXT


              14.CONFIRMATION TEST

                NEXT

                END