Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

KINETIC DYNAMIC SUSPENSION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.
    Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Kinetic Dynamic Suspension System 
Symptom
Suspected Area
See page
Kinetic dynamic suspension system DTC cannot be output (When using Techstream)
CAN communication system
Click here
Harness or connector (power source of stabilizer control ECU)
Click here
Stabilizer control ECU
Click here
Kinetic dynamic suspension system DTC cannot be output (When not using Techstream)
CAN communication system
Click here
Harness or connector (power source of stabilizer control ECU)
Click here
Stabilizer control ECU
Click here
Combination meter
Click here
KDSS indicator light does not come on
CAN communication system
Click here
Harness or connector (power source of stabilizer control ECU)
Click here
Combination meter
Click here
Vehicle is tilted
Stabilizer control solenoid valve
Click here
Fluid leakage
Click here
Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid)
Click here
Roll is not controlled when driving
Brake control system
Click here
Stabilizer control solenoid valve
Click here
Fluid leakage
Click here
Bleed air (check for clogs in hydraulic circuit and lack or excess of fluid)
Click here
Accumulator pressure sensor
Click here