Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE UPPER RADIATOR SUPPORT SEAL


3. REMOVE FRONT FENDER MAIN SEAL LH


    E198982
  1. Detach the 4 clips and 2 guides and remove the front fender main seal LH.



4. REMOVE FRONT FENDER MAIN SEAL RH

HINT:
Use the same procedure described for the LH side.



5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    E198989
  1. Detach the 5 claws and remove the front fender to cowl side seal LH.



6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:
Use the same procedure described for the LH side.



7. REMOVE FRONT WIPER ARM HEAD CAP


    E198979E01
  1. Using a screwdriver, detach the 3 claws and remove the front wiper arm head cap.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure described for the LH side.

    Text in Illustration 
    *1
    Protective Tape



8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E198980
  1. Remove the nut and the front wiper arm and blade assembly LH.



9. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E198981
  1. Remove the nut and the front wiper arm and blade assembly RH.



10. REMOVE CENTER NO. 2 COWL TOP VENTILATOR LOUVER


    E198983
  1. Detach the 2 claws and 2 guides and remove the center No. 2 cowl top ventilator louver.



11. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E198984E01
  1. Remove the 2 clips.

  1. Detach the 6 claws and guide (A).
    Text in Illustration 
    *1
    Guide A
    *2
    Guide B

  1. Detach the 9 guides (B) and pull out the cowl top ventilator louver sub-assembly.



12. REMOVE WINDSHIELD WIPER MOTOR AND LINK


    E198985
  1. Detach the clamp and disconnect the connector.



    E198986
  1. Remove the 2 bolts.



    E198987E01
  1. Detach the grommet and remove the windshield wiper motor and link as shown in the illustration.
    Text in Illustration 
    *1
    Grommet

    NOTICE:
    Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



13. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E197622E01
  1. Using a screwdriver, separate the windshield wiper link rod from the crank arm pivot of the front wiper crank sub-assembly as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



    E197625
  1. Disconnect the connector.

  1. Using a T30 "TORX" socket, remove the 2 bolts and windshield wiper motor.



14. REMOVE WIPER MOTOR WIRE


    E197627
  1. Detach the claw and remove the wiper motor wire.