Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
Either condition is met:
  1. "ECM (Engine)" is not displayed on the "CAN Bus Check" screen.
  1. "ECM Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside ECM
  2. ECM

WIRING DIAGRAM


C217716E04


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)


  1. Disconnect the B38, B39 and F51 ECM connectors.


    C217328E02


    Text in Illustration 
    *a
    Front view of wire harness connector
    (to ECM)
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B38-12 (E1) - Body ground
    Always
    Below 1 Ω
    B39-10 (ME01) - Body ground
    Always
    Below 1 Ω
    B39-14 (E01) - Body ground
    Always
    Below 1 Ω
    B39-15 (E02) - Body ground
    Always
    Below 1 Ω
    F51-12 (EC) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F51-24 (BATT) - Body ground
    Always
    11 to 14 V
    F51-23 (+B2) - Body ground
    Battery positive (+) voltage applied to terminal F51-9 (MREL)
    11 to 14 V
    F51-22 (+B) - Body ground
    Battery positive (+) voltage applied to terminal F51-9 (MREL)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)