Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the steering lock system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK DTC*
    1. Check for DTCs and make a note of any codes that are output (Click here).

    2. Clear the DTCs (Click here).

    3. Recheck for DTCs (Click here). Based on the DTCs output above, try to cause the output of the same wireless door lock control system DTC, LIN communication system DTC, steering lock system DTC, engine immobiliser system DTC or smart key system (for entry function) DTC by reproducing the symptoms indicated by the DTC.
      Result 
      Result
      Proceed to
      DTC is not output.
      A
      Wireless door lock control system DTC is output.
      B
      LIN communication system DTC is output.
      C
      Steering lock system DTC is output.
      D
      Engine immobiliser system DTC is output.
      E
      Smart key system (for entry function) DTC is output.
      F



    B.
    Go to WIRELESS DOOR LOCK CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)

    C.
    Go to LIN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)

    D.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)

    E.
    Go to ENGINE IMMOBILISER SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)

    F.
    Go to SMART KEY SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table.
      A
      Fault is listed in problem symptoms table.
      B



    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List / Active Test (Click here).


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END