Item
| Function
|
Steering lock actuator assembly
| Consists of a motor, lock bar, lock and unlock position sensors, etc. activated by the steering lock ECU.
|
Steering lock ECU
| - Included in the steering lock actuator assembly. This ECU activates the steering lock motor based on permission signals from the certification ECU.
- Records ECU verification codes.
|
Power management control ECU
| - Permits the steering lock ECU to supply power to activate the motor.
- Performs power supply switching control.
- Controls the engine switch indicator.
- Operates the IG2 relay.
|
Certification ECU
| - Performs key verification (checks whether the correct key is present).
- Controls the security indicator and the illumination of the lettering on the engine switch.
- Records ECU verification codes.
|
IG2 relay
| Controlled by the power management control ECU. Signals indicating the on/off status of this relay are sent to the power management control ECU and steering lock ECU.
|
ID code box
| - Transmits a command to set or cancel the immobiliser to the ECM based on permission signals from the certification ECU.
- Records ECU verification codes.
|