Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

DTC    B2788    IG2 Signal Malfunction

for Preparation Click here


DESCRIPTION

The steering lock ECU determines the on/off status of the engine switch through the IG2 signal circuit.
The steering lock ECU does not lock the steering when it receives the IG2 relay on signal. This prevents the steering from being locked while the vehicle is moving.
The diagnosis information of the steering lock ECU is transmitted to the Techstream via the certification ECU as the steering lock ECU is not connected to the CAN communication system.

DTC Code
Detection Condition
Trouble Area
B2788
The IG2 input to the steering lock ECU does not match the LIN communication input.
  1. IGN fuse
  2. Steering lock actuator assembly (steering lock ECU)
  3. Power management control ECU
  4. Harness or connector

WIRING DIAGRAM


C198342E06


INSPECTION PROCEDURE

HINT:
When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:
With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.

NOTICE:
  1. If the steering lock actuator assembly (steering lock ECU) is replaced, with the engine switch off and the shift lever in P, open and close the driver side door to record the current lock position into the steering lock ECU. If this is not performed, the engine may not start.
  2. When replacing the steering lock ECU, registration must be performed (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)


    C202099E13
  1. Disconnect the F68 steering lock ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F68-1 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Lock ECU)



    C197722E23
  1. Reconnect the F68 steering lock ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F68-6 (IG2) - F68-1 (GND)
    Engine switch on (IG)
    11 to 14 V
    F68-6 (IG2) - F68-1 (GND)
    Engine switch off
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Steering Lock ECU)



NG
CHECK FOR SHORT IN ALL HARNESSES, CONNECTORS AND COMPONENTS CONNECTED TO IG2 FUSE
OK

REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) (Click here)