Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM


E283660E01


INSPECTION PROCEDURE

NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    E225824E46
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N11-1 (MUTE) - Body ground
    Ignition switch ACC, audio system playing
    → Changing modes
    Above 3.5 V
    → Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Stereo Component Amplifier Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the G37 navigation receiver assembly connector.

  1. Disconnect the N11 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G37-16 (MUT1) - N11-1 (MUTE)
    Always
    Below 1 Ω
    G37-16 (MUT1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)
  1. Reconnect the N11 stereo component amplifier assembly connector.

  1. Disconnect the G37 navigation receiver assembly connector.



    E221772E26
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G37-16 (MUT1) - Body ground
    Ignition switch ACC, audio system is playing
    Above 3.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Navigation Receiver Assembly)



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)