STEREO COMPONENT AMPLIFIER > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat) |
![]() |
Using a screwdriver, detach the 2 claws to remove the rear No. 1 floor step cover.
| *1 | Protective Tape |
| 3. REMOVE QUARTER SCUFF PLATE INNER RH (w/ Rear No. 2 Seat) |
| 4. REMOVE REAR DOOR SCUFF PLATE RH |
| 5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH |
| 6. REMOVE OUTER LAP BELT ANCHOR COVER |
![]() |
Detach the 3 claws to remove the outer lap belt anchor cover.
| 7. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board) |
![]() |
Detach the 4 claws to open the cover.
![]() |
Remove the bolt, luggage hold belt striker and No. 1 luggage compartment trim cover.
| *1 | Luggage Hold Belt Striker |
| 8. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board) |
![]() |
Detach the clip to remove the No. 1 deck board sub-assembly.
| 9. REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER (w/ Deck Board, w/o Rear No. 2 Seat) |
![]() |
Detach the 2 claws to open the cover.
![]() |
Remove the bolt, luggage hold belt striker and No. 2 luggage compartment trim cover.
| *1 | Luggage Hold Belt Striker |
| 10. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Deck Board) |
![]() |
Detach the 2 clips and 2 guides to remove the No. 2 deck board sub-assembly.
| 11. REMOVE REAR NO. 2 FLOOR BOARD ASSEMBLY (w/ Deck Board) |
![]() |
Detach the 3 clips to remove the rear No. 2 floor board assembly.
| 12. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH (w/ Deck Board) |
![]() |
Using a screwdriver, detach the 4 clips and 2 guides to remove the luggage compartment side cover sub-assembly LH.
| *1 | Protective Tape |
| 13. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH (w/ Deck Board) |
| 14. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board) |
![]() |
Remove the 6 bolts.
Detach the 2 guides to remove the deck board assembly.
| 15. REMOVE INNER FLOOR SIDE RAIL SUB-ASSEMBLY (w/ Deck Board) |
![]() |
Remove the 4 bolts and inner floor side rail sub-assembly.
| 16. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE |
![]() |
Detach the 5 clips to remove the rear floor mat rear support plate.
| 17. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board) |
![]() |
Detach the 4 claws to remove the rear floor carpet assembly.
| 18. REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER |
![]() |
Detach the 3 claws to remove the rear No. 1 seat outer lap belt anchor cover.
| 19. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
![]() |
Remove the No. 1 luggage compartment trim hook by turning it clockwise.
| 20. REMOVE FRONT DECK SIDE TRIM COVER RH |
| 21. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER |
![]() |
Detach the 2 claws to open the cover.
![]() |
Remove the bolt, luggage hold belt striker and No. 2 luggage compartment trim cover.
| *1 | Luggage Hold Belt Striker |
| 22. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
w/o Rear No. 2 Seat:
![]() |
Remove the bolt to disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and screw.
Detach the 7 clips, 5 claws and 2 guides.

Disconnect each connector.
![]() |
Detach the 6 claws and 2 guides and pass the rear seatback lock control lever base through the deck trim side panel assembly RH to remove the deck trim side panel assembly RH.
w/ Rear No. 2 Seat:
![]() |
Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
![]() |
Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.
Remove the 3 bolts and screw.
Detach the 7 clips, 5 claws and 2 guides.
Disconnect each connector and remove the deck trim side panel assembly RH.

| 23. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY |
![]() |
Disconnect the 4 connectors.
Remove the 3 bolts.
Detach the 2 claws and remove the stereo component amplifier.