Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Rear Side)

WASHER NOZZLE (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR WASHER NOZZLE


    E199096
  1. Connect the washer hose.



    E199095
  1. Attach the 2 claws to install the rear washer nozzle.



2. INSPECT REAR WASHER NOZZLE


  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.



    E199093E01


    Text in Illustration 
    *1
    Ceramic Line
    -
    -
    *a
    Wiping Pattern
    -
    -
    V100155
    Washer Fluid Spray Area
    -
    -

    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    300.8 mm (11.8 in.)
    B
    235.1 mm (9.26 in.)
    C
    110.8 mm (4.36 in.)
    D
    81 mm (3.19 in.)
    E
    328.8 mm (12.9 in.)
    F
    278.2 mm (10.9 in.)
    G
    230.7 mm (9.08 in.)
    H
    322.7 mm (12.7 in.)

    If the result is not as specified, replace the malfunctioning rear washer nozzle.



3. ADJUST REAR WASHER NOZZLE


    E185207
  1. Using a screwdriver, adjust the direction of the rear washer nozzle.

    HINT:
    Use a thin-bladed screwdriver with a tip approximately 1 mm (0.0394 in.) thick.

    NOTICE:
    Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.



4. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    E199088E02
  1. Clean the wiper arm serrations.
    Text in Illustration 
    *1
    Wiper Arm Pivot Serrations



    E199087E01
  1. Clean the wiper pivot serrations with a wire brush.
    Text in Illustration 
    *1
    Wiper Pivot Serrations
    *2
    Wire Brush

  1. Operate the rear wiper and stop the rear wiper motor at the automatic stop position.

    HINT:
    The wiper motor does not operate if the back door and back door glass are not closed.



    E199089E01
  1. With the rear wiper blade and linear wiper step in the positions shown in the illustration, install the rear wiper blade assembly with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    Text in Illustration 
    *A
    Tightening Position
    *1
    Linear Wiper Step
    *2
    Wiper Blade Rubber Block
    *3
    Wiper Blade

    HINT:
    Hold the arm hinge down by hand while tightening the nut.



    E199090E01
  1. Place the rear wiper blade assembly in the automatic stop position.
    Text in Illustration 
    *A
    Rise-up Position
    *1
    Linear Wiper Step
    *2
    Wiper Blade Rubber Block
    *3
    Wiper Blade



5. INSTALL REAR SPOILER SUB-ASSEMBLY
  1. Install the rear spoiler sub-assembly (Click here).