Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY

FRONT PROPELLER SHAFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
  1. Align the matchmarks on the yoke and differential flange.

  1. Install the propeller shaft assembly with the 4 washers, 4 bolts and 4 nuts.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }

  1. Align the matchmarks on the yoke and transfer flange.

  1. Install the propeller shaft assembly with the 4 washers and 4 nuts.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



2. INSTALL FRONT EXHAUST PIPE
  1. Install the front exhaust pipe (Click here).