Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0129    Lost Communication with Skid Control ECU

DTC    U0131    Lost Communication with Power Steering Control Module

DTC    U0151    Lost Communication with Airbag ECU

for Preparation Click here


DESCRIPTION

The combination meter assembly communicates with the ECM via the CAN communication system (CAN No. 1 Bus).

DTC Code
DTC Detection Condition
Trouble Area
U0100
IG voltage is 9.5 V or higher and the following condition is met:
  1. No communication with the ECM continues for 2 seconds or more.
  1. ECM
  2. CAN communication system
  3. Combination meter assembly
U0129
IG voltage is 9.5 V or higher and the following condition is met:
  1. No communication with the skid control ECU continues for 3 seconds or more.
  1. Master cylinder solenoid (Skid control ECU)
  2. CAN communication system
  3. Combination meter assembly
U0131
IG voltage is 9.5 V or higher and the following condition is met:
  1. No communication with the power steering ECU continues for 3 seconds or more.
  1. Power steering ECU assembly
  2. CAN communication system
  3. Combination meter assembly
U0151
IG voltage is 9.5 V or higher and the following condition is met:
  1. No communication with the center airbag sensor assembly continues for 10 seconds or more.
  1. Center airbag sensor assembly
  2. CAN communication system
  3. Combination meter assembly

INSPECTION PROCEDURE

1.CONFIRM DTC OUTPUT
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    If CAN communication system DTC U0100, U0129, U0131 or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131 or U0151 first.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)