Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR

REAR WIPER MOTOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE REAR NO. 1 SPOILER COVER


B240307
  1. Detach the 4 clips and remove the rear No. 1 spoiler cover.



3. REMOVE REAR SPOILER SUB-ASSEMBLY


    B240308
  1. Remove the 4 grommets and 4 bolts.



    B240309E01
  1. Put protective tape around the rear spoiler.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the connector.

  1. Detach the 3 claws and remove the rear spoiler.



4. REMOVE REAR WIPER ARM AND BLADE ASSEMBLY


    E198997
  1. Remove the nut and rear wiper blade assembly.



5. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY


    E198998
  1. Disconnect the connector.

  1. Loosen the 3 bolts.

    NOTICE:
    Do not try to remove the bolts since they are integrated with the motor.

  1. Detach the 2 guides and remove the rear wiper motor