REAR WIPER MOTOR > INSTALLATION |
| 1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY |
![]() |
Attach the 2 guides and temporally install the rear wiper motor and bracket assembly with the 3 bolts.
Tighten the 3 bolts.
Connect the connector.
| 2. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY |
![]() |
Clean the wiper arm serrations.
| *1 | Wiper Arm Pivot Serrations |
![]() |
Clean the wiper pivot serrations with a wire brush.
| *1 | Wiper Pivot Serrations |
| *2 | Wire Brush |
Operate the rear wiper and stop the rear wiper motor at the automatic stop position.
![]() |
With the rear wiper blade and linear wiper step in the positions shown in the illustration, install the rear wiper blade assembly with the nut.
| *A | Tightening Position |
| *1 | Linear Wiper Step |
| *2 | Wiper Blade Rubber Block |
| *3 | Wiper Blade |
![]() |
Place the rear wiper blade assembly in the automatic stop position.
| *A | Rise-up Position |
| *1 | Linear Wiper Step |
| *2 | Wiper Blade Rubber Block |
| *3 | Wiper Blade |
| 3. INSTALL REAR SPOILER SUB-ASSEMBLY |
Attach the 3 claws to install the rear spoiler.
Connect the connector.
Install the 4 bolts and 4 grommets.
| 4. INSTALL REAR NO. 1 SPOILER COVER |
Attach the 4 clips to install the rear No. 1 spoiler cover.
| 5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |