Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Taillight Relay Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit of the clearance warning ECU assembly.

WIRING DIAGRAM


E200013E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK TAILLIGHT
  1. Turn the light control switch to the TAIL position.

  1. Check that the taillight turns on.

    OK:
    Taillight turns on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)


    E282886E01
  1. Disconnect the F95 clearance warning ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F95-24 (TL) - Body ground
    Ignition switch ON, light control switch TAIL
    11 to 14 V
    Ignition switch ON, light control switch not TAIL
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)