Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP

VANE PUMP > REMOVAL

for Preparation Click here


NOTICE:
  1. When using a vise, do not overtighten it.
  2. When installing the parts indicated by arrows, coat them with power steering fluid (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT WHEEL RH


3. REMOVE FRONT FENDER APRON SEAL RH


    A223336
  1. Remove the 4 clips and front fender apron seal RH.



4. REMOVE V-BANK COVER SUB-ASSEMBLY


    A229925E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then detach the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    V-bank Cover Hook



5. REMOVE AIR CLEANER CAP AND HOSE


    A224721
  1. Remove the air cleaner cap and hose.

    1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

    2. Loosen the clamp.

    3. Unfasten the 4 hook clamps, and then remove the bolt and air cleaner cap and hose.



6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


7. REMOVE AIR CLEANER CASE
  1. Remove the air cleaner filter element sub-assembly.



    A224715
  1. Detach the wire harness clamp.

  1. Remove the 3 bolts and air cleaner case sub-assembly.



8. REMOVE FAN AND GENERATOR V BELT


    A217571
  1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.



9. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


    C215461
  1. Disconnect the 2 connectors.



10. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    C215462
  1. Slide the clip and disconnect the oil reservoir to pump hose from the vane pump.



11. DISCONNECT NO. 1 PRESSURE FEED TUBE


    C215463
  1. Remove the union bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



12. REMOVE VANE PUMP ASSEMBLY


    C216288
  1. Remove the bolt and harness bracket.



    C216289
  1. Remove the 2 bolts and vane pump.