Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

AUTOMATIC RUNNING BOARD SYSTEM > Side Auto Step Switch Circuit

for Preparation Click here


DESCRIPTION

The side auto step controller ECU assembly receives the door open/closed signal from each door courtesy light switch via the side auto step switch assembly.

WIRING DIAGRAM


B295284E01


INSPECTION PROCEDURE

HINT:
Inspection should be performed on the door courtesy switch circuit on the side where the automatic running board is malfunctioning.

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP SWITCH - SIDE AUTO STEP CONTROLLER ECU)
  1. Disconnect the F90 side auto step switch assembly connector.

  1. Disconnect the A42 side auto step controller ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    for LH 
    Tester Connection
    Condition
    Specified Condition
    F90-4 (ECU1) - A42-14 (CTY1)
    Always
    Below 1 Ω
    for RH 
    Tester Connection
    Condition
    Specified Condition
    F90-6 (ECU2) - A42-13 (CTY2)
    Always
    Below 1 Ω


    Standard Resistance (Check for Short):
    for LH 
    Tester Connection
    Condition
    Specified Condition
    A42-14 (CTY1) - Body ground
    Always
    10 kΩ or higher
    for RH 
    Tester Connection
    Condition
    Specified Condition
    A42-13 (CTY2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)