Home › Suspension › SUSPENSION CONTROL › KINETIC DYNAMIC SUSPENSION SYSTEM

DTC    C1879/79    Zero Point Calibration of Acceleration Sensor Undone

for Preparation Click here


DESCRIPTION

The stabilizer control ECU receives the yaw rate and acceleration sensor zero point information from the skid control ECU via CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C1879/79
A signal indicating that the yaw rate and acceleration sensor zero point calibration has not been performed is continuously received from the skid control ECU for 5 seconds.
  1. Brake control system (Yaw rate and acceleration sensor zero point calibration)
  2. Stabilizer control ECU

INSPECTION PROCEDURE

HINT:
When this DTC is output, obtain the calibration value of the yaw rate and acceleration sensor zero point first.

1.PERFORM ZERO POINT CALIBRATION
  1. Perform brake control system calibration (Click here).


NEXT


2.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE STABILIZER CONTROL ECU (Click here)