Home › Suspension › SUSPENSION CONTROL › STABILIZER CONTROL ECU

STABILIZER CONTROL ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag assembly (Click here).



3. REMOVE STABILIZER CONTROL ECU


C212825
  1. Disconnect the connector.

  1. Remove the bolt and stabilizer control ECU.

    NOTICE:
    1. Avoid any impact to the stabilizer control ECU.
    2. Replace the stabilizer control ECU with a new one if it is dropped.