Home › Suspension › SUSPENSION CONTROL › STABILIZER CONTROL VALVE (w/ KDSS)

STABILIZER CONTROL VALVE (w/ KDSS) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT WHEEL


3. REMOVE REAR WHEEL


4. REMOVE SIDE STEP ASSEMBLY LH


  1. Remove the 6 bolts and side step.


    B239976



5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



6. REMOVE STABILIZER CONTROL VALVE PROTECTOR


    C212853
  1. Remove the 2 bolts and stabilizer control valve protector.



7. DRAIN SUSPENSION FLUID


    C212854
  1. Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.

    HINT:
    1. Drain suspension fluid when performing operations related to the hydraulic circuits.
    2. Draining suspension fluid decreases suspension fluid pressure.

  1. Tighten the bleeder plug.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



8. REMOVE FRONT STABILIZER TUBE PROTECTOR


    C212855
  1. Remove the 2 bolts and front stabilizer tube protector.



9. REMOVE FRONT STABILIZER CONTROL TUBE INSULATOR


    C213637
  1. Remove the 2 bolts and front stabilizer control tube insulator.



10. REMOVE FRONT STABILIZER CONTROL TUBE



C214843

  1. Using a union nut wrench, disconnect the 4 flare nuts.

  1. Remove the 2 bolts and front stabilizer control tubes.



11. REMOVE REAR STABILIZER CONTROL TUBE



C214844

  1. Using a union nut wrench, disconnect the 2 flare nuts.

  1. Remove the 2 union bolts of the rear stabilizer control cylinder and the 2 pressure port gaskets.

  1. Remove the 4 bolts and rear stabilizer control tubes.



12. REMOVE STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY


    C214833
  1. Disconnect the connector, and then detach the clamp from the sensor bracket.

  1. Remove the 3 bolts and stabilizer control with accumulator housing.

    NOTICE:
    Do not disassemble the stabilizer control with accumulator housing assembly or expose it to an open flame as the accumulator of the stabilizer control with accumulator housing assembly contains gas.