Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL CRUISE CONTROL MAIN SWITCH


    B237284
  1. Install the switch with the 2 screws.



    B239745
  1. Connect the connector.



2. INSTALL STEERING PAD


    B238311
  1. Support the steering pad with one hand.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.

  1. Using a T30 "TORX" socket wrench, tighten the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



3. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    B238308E01
  1. Attach the 2 claws to install the cover.
    Text in Illustration 
    *A
    w/o Cruise Control System
    *B
    w/ Cruise Control System



4. INSTALL LOWER NO. 3 STEERING WHEEL COVER
  1. Attach the 2 claws to install the cover.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).