Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

DTC    B1500    Fuel Sender Open Detected

for Preparation Click here


DESCRIPTION

This DTC is stored when the combination meter detects a fuel sender gauge malfunction.

DTC Code
DTC Detection Condition
Trouble Area
B1500
IG voltage is 9.5 V or higher and the following condition is met:
1. Fuel sender gauge operation malfunction.
  1. Harness or connector
  2. Combination meter assembly
  3. Fuel suction with pump and gauge tube assembly
  4. Fuel sender gauge assembly

WIRING DIAGRAM


E185311E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (FUEL SENDER GAUGE)
  1. Use the Data List to check if the fuel receiver gauge is operating properly (Click here).

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Fuel Input
    Fuel input signal/Min.: 0, Max.: 127.5
    Current fuel level displayed
    Unit: Liter

    OK:
    Fuel amount value displayed on the Techstream is almost the same as needle indication.

    Result 
    Result
    Proceed to
    NG
    A
    OK
    B



B
REPLACE COMBINATION METER ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - FUEL SUCTION WITH PUMP AND BODY GROUND)
  1. Disconnect the F14 meter connector.

  1. Disconnect the Q5 gauge connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F14-40 (L) - Q5-2 (FS)
    Always
    Below 1 Ω
    F14-19 (E3) - Q5-3 (FE)
    F14-20 (E1) - Body ground
    F14-40 (L) or Q5-2 (FS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY


    E180164E06
  1. Remove the fuel suction with pump and gauge tube assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-2 (FS) - B-2
    Always
    Below 1 Ω
    A-3 (FE) - B-3

Text in Illustration 
*a
Upper Side
*b
Lower Side (to Fuel Sender Gauge Assembly)
*c
Connector A
*d
Connector B


NG
REPLACE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (Click here)
OK


4.INSPECT FUEL SENDER GAUGE ASSEMBLY


    A223150E03
  1. Remove the fuel sender gauge (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 - 3
    Float level F (upper)
    12 to 18 Ω
    Float level E (lower)
    405 to 415 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector (to Fuel Sender Gauge Assembly)
    *b
    Float level F (upper)
    *c
    Float level E (lower)



NG
REPLACE FUEL SENDER GAUGE ASSEMBLY (Click here)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)