Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 2 SWITCH HOLE BASE


    B239275
  1. Detach the 6 clips and 2 guides.

  1. Disconnect each connector and remove the No. 2 switch hole base.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    B239279
  1. w/o Smart Key System:

    1. Detach the 4 clips.

    2. Disconnect the cooler thermistor and remove the lower instrument panel finish panel assembly.



    B239276
  1. w/ Smart Key System:

    1. Detach the 4 clips.

    2. Disconnect the connector and cooler thermistor and remove the lower instrument panel finish panel assembly.



4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
  1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.



    E196438E01
  1. Place protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 4 claws.



    E196439
  1. Detach the 7 clips and remove the finish panel.



5. REMOVE COMBINATION METER ASSEMBLY


    E196440
  1. Remove the 4 screws.

  1. Disconnect the connectors and remove the combination meter by pulling it up in the direction of the arrow in the illustration.