Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2789    No Response from ID BOX

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the certification ECU and ID code box stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2789
No communication between the certification ECU and ID code box for 10 seconds or more.
  1. ID code box
  2. Certification ECU
  3. Harness or connector

WIRING DIAGRAM


C211493E09


INSPECTION PROCEDURE

NOTICE:
  1. When using the Techstream with the ignition switch off to troubleshoot:
    Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
  2. Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

HINT:
When communication between the ID code box and certification ECU stops, DTC B2785 is also stored.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2789 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)
  1. Disconnect the F79 certification ECU connector.

  1. Disconnect the F72 ID code box connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F79-29 (LIN) - F72-3 (LIN1)
    Always
    Below 1 Ω
    F79-29 (LIN) or F72-3 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)


    C216967E01
  1. Disconnect the F72 ID code box connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F72-8 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F72-1 (+B) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to ID Code Box)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE ID CODE BOX
  1. Temporarily replace the ID code box with a new one (Click here).


NEXT


6.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2789 is not output.



NG
REPLACE CERTIFICATION ECU (Click here)
OK

END (ID CODE BOX IS DEFECTIVE)