Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › CERTIFICATION ECU

CERTIFICATION ECU > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE COWL SIDE TRIM BOARD RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B239284
  1. Detach the 3 clips and 2 guides to remove the No. 2 instrument panel under cover sub-assembly.



5. REMOVE LOWER INSTRUMENT COVER LH


    B239283E01
  1. Put protective tape around the lower instrument cover LH.

  1. Using a screwdriver, detach the 4 claws to remove the lower instrument cover LH.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    B240162
  1. Remove the 3 bolts.

  1. Detach the 8 claws and remove the instrument panel airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



7. REMOVE INSTRUMENT PANEL BOX DOOR COVER


    B239281E01
  1. Using a screwdriver, detach the 2 claws and 2 guides to remove the instrument panel box door cover.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for all the instrument panel box door covers.



8. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    B239282
  1. Remove the 3 screws <B> and 2 bolts <C>.

  1. Detach the 10 clips and guide.

  1. Disconnect each connector and remove the lower instrument panel sub-assembly.



9. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    E197382
  1. Remove the screw.

  1. Detach the 2 claws and remove the air duct.



10. REMOVE ECU INTEGRATION BOX RH


    B240503
  1. Disconnect the connectors and detach the clamp.

  1. Remove the 2 nuts, bolt and the certification ECU with seat belt control ECU.



11. REMOVE CERTIFICATION ECU


    B240504
  1. Detach the 2 claws and remove the certification ECU.