Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2786    No Response from Steering Lock ECU

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the certification ECU and steering lock actuator assembly (steering lock ECU) stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2786
LIN communication between the certification ECU and steering lock ECU stops for 10 seconds or more.
  1. Steering lock actuator assembly (steering lock ECU)
  2. Certification ECU
  3. Harness or connector

WIRING DIAGRAM


C217632E06


INSPECTION PROCEDURE

NOTICE:
  1. When using the Techstream with the ignition switch off to troubleshoot:
    Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
  2. Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

HINT:
When communication between the steering lock ECU and certification ECU stops, DTC B2785 is also stored.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2786 is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)
  1. Disconnect the F79 certification ECU connector.

  1. Disconnect the F68 steering lock actuator assembly (steering lock ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F79-29 (LIN) - F68-5 (LIN)
    Always
    Below 1 Ω
    F79-29 (LIN) or F68-5 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BATTERY AND BODY GROUND)


    C216966E01
  1. Disconnect the F68 steering lock actuator assembly (steering lock ECU) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F68-1 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F68-6 (IG2) - Body ground
    Ignition switch ON
    11 to 14 V
    F68-7 (B) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Steering Lock Actuator Assembly [Steering Lock ECU])


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)
  1. Temporarily replace the steering lock actuator (steering lock ECU) assembly with a new one (Click here).


NEXT


6.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2786 is not output.



NG
REPLACE CERTIFICATION ECU (Click here)
OK

END (STEERING LOCK ECU IS DEFECTIVE)