Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A223685E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly LH.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *a
    Fulcrum Length

    NOTICE:
    Do not use the air fuel ratio sensor if it has been subjected to physical shocks, such as being dropped, etc.

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.



2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A223683E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly RH.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    Text in Illustration 
    *a
    Fulcrum Length

    NOTICE:
    Do not use the air fuel ratio sensor if it has been subjected to physical shocks, such as being dropped, etc.

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Click here).
    2. Make sure SST and the wrench are connected in a straight line.



3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY
(Click here)