Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY
(Click here)


2. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A223682E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly RH.

    SST
    09224-00010  

    NOTICE:
    Do not use the air fuel ratio sensor if it has been subjected to physical shocks, such as being dropped, etc.



3. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A223684E01
  1. Using SST, remove the air fuel ratio sensor from the exhaust manifold sub-assembly LH.

    SST
    09224-00010  

    NOTICE:
    Do not use the air fuel ratio sensor if it has been subjected to physical shocks, such as being dropped, etc.