Home › Drivetrain ยท A750F AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET
  1. Install the console box mounting bracket with the 2 screws.



2. INSTALL SHIFT LEVER ASSEMBLY



C217016E01

  1. Install the transmission floor shift with the 4 bolts tighten the bolt in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the 2 connectors and attach the 4 wire harness clamps.



3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


  1. Turn the socket of the transmission control cable 180° counterclockwise. While holding the socket in place, push in the lock piece until the lock piece clicks twice.

    NOTICE:
    Do not over-rotate the socket as it will come off the internal spring and the transmission control cable will not be reusable.



    C216621E02


    Text in Illustration 
    *1
    Socket
    *2
    Lock Piece
    *a
    Push in
    -
    -

    HINT:
    If the lock piece cannot be pushed in, slightly turn the socket clockwise and then push in the lock piece again.



  1. Install the outer part of the transmission control cable to the shift lever retainer. Check that the socket and lock piece are positioned at original position.


    C216998E01


    Text in Illustration 
    *1
    Shift Lever Retainer
    -
    -



    C203381E01
  1. Slide the slider in the direction shown in the illustration and pull out the lock piece.
    Text in Illustration 
    *1
    Slider
    *2
    Lock Piece



    C204586
  1. Connect the end of the cable to the shift lever.

    NOTICE:
    1. Make sure that the lock piece is pulled up.
    2. Push on the end of the cable all the way to the base of the pin.



    C204598E04
  1. Push the lock piece into the adjuster case and lock it.

    NOTICE:
    Make sure that the lock piece is completely locked by the slider.



4. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch to on (IG) and the brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the transmission floor shift assembly installation condition.



5. INSTALL REAR CONSOLE BOX ASSEMBLY
  1. Install the rear console box (Click here).