SHIFT LEVER > INSTALLATION |
| 1. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET |
Install the console box mounting bracket with the 2 screws.
| 2. INSTALL SHIFT LEVER ASSEMBLY |

Install the transmission floor shift with the 4 bolts tighten the bolt in the order shown in the illustration.
Connect the 3 connectors and attach the 4 wire harness clamps.
| 3. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
Turn the socket of the transmission control cable 180° counterclockwise. While holding the socket in place, push in the lock piece until the lock piece clicks twice.

| *1 | Socket | *2 | Lock Piece |
| *a | Push in | - | - |
Install the outer part of the transmission control cable to the shift lever retainer. Check that the socket and lock piece are positioned at original position.

| *1 | Shift Lever Retainer | - | - |
![]() |
Slide the slider in the direction shown in the illustration and pull out the lock piece.
| *1 | Slider |
| *2 | Lock Piece |
![]() |
Connect the end of the cable to the shift lever.
![]() |
Push the lock piece into the adjuster case and lock it.
| 4. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from P to R with the ignition switch to on (IG) and the brake pedal depressed, make sure that it moves smoothly and correctly into position.
Check that the shift lever does not stop when moving the shift lever from R to P, and check that the shift lever does not stick when moving the shift lever from D to S.
Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves in reverse after moving the shift lever to R.
If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the transmission floor shift assembly installation condition.
| 5. INSTALL REAR CONSOLE BOX ASSEMBLY |
Install the rear console box (Click here).