Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER

NAVIGATION RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 RADIO BRACKET
  1. Install the No. 2 radio bracket with the 5 screws.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }



2. INSTALL NO. 1 RADIO BRACKET
  1. Install the No. 1 radio bracket with the 5 screws.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }



3. INSTALL HAZARD SWITCH WIRE
  1. Connect the connector.

  1. Attach the 2 clamps to install the hazard switch wire.



4. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS
  1. Connect each connector.



    B352863
  1. Insert the navigation receiver assembly with brackets to attach the 6 claws on its backside.

    NOTICE:
    When inserting the navigation receiver assembly with brackets, do not press its knobs on it.

  1. Install the navigation receiver assembly with brackets with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



5. INSTALL HEATER CONTROL ASSEMBLY


    E202383
  1. Attach the 4 clips to install the heater control assembly.



6. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.



7. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



9. CHECK SRS WARNING LIGHT
(Click here)