Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Indicator Circuit

for Preparation Click here


DESCRIPTION

The warning indicator lights are installed in the combination meter assembly.

WIRING DIAGRAM


E282889E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY)


    E200096E10
  1. Disconnect the F14 combination meter assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F14-17 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Combination Meter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the F95 clearance warning ECU assembly connector.

  1. Disconnect the F14 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F95-9 (L4) - F14-35 (FR)
    Always
    Below 1 Ω
    F95-26 (L5) - F14-32 (FL)
    Always
    Below 1 Ω
    F95-28 (L1) - F14-7 (RR)
    Always
    Below 1 Ω
    F95-29 (L2) - F14-12 (RL)
    Always
    Below 1 Ω
    F95-30 (L3) - F14-18 (BK)
    Always
    Below 1 Ω
    F95-31 (L10) - F14-31 (OP)
    Always
    Below 1 Ω
    F95-9 (L4) - Body ground
    Always
    10 kΩ or higher
    F95-26 (L5) - Body ground
    Always
    10 kΩ or higher
    F95-28 (L1) - Body ground
    Always
    10 kΩ or higher
    F95-29 (L2) - Body ground
    Always
    10 kΩ or higher
    F95-30 (L3) - Body ground
    Always
    10 kΩ or higher
    F95-31 (L10) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)