Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEREO JACK ADAPTER ASSEMBLY

STEREO JACK ADAPTER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY
  1. Attach the 2 claws to install the No. 1 stereo jack adapter assembly.



2. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Climate Control Seat System)
  1. Connect 2 connectors.

  1. Attach the 4 clips to install the lower center instrument cluster finish panel sub-assembly.

  1. Install the 2 screws <B>.



3. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Climate Control Seat System)
  1. Connect 3 connectors.

  1. Attach the 4 clips to install the lower center instrument cluster finish panel sub-assembly.

  1. Install the 2 screws <B>.



4. INSTALL NO. 2 CONSOLE BOX RETAINER
  1. Attach the clip, 2 claws and 2 guides to install the No. 2 console box retainer.



5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
  1. Connect each connector.



  1. Attach the 10 clips to install the upper console panel sub-assembly.


    B354448E01


    Text in Illustration 
    *A
    for VF2A
    *B
    for VF2BM, VF4BM
    *C
    for 2WD
    -
    -



6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)


    B353462
  1. Install the shift lever knob sub-assembly and turn it in the direction indicated by the arrow.



7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B353463
  1. Install the shift lever knob sub-assembly and turn it in the direction indicated by the arrow.



8. INSTALL HEATER CONTROL ASSEMBLY


    E202383
  1. Attach the 4 clips to install the heater control assembly.



9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.



10. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.



11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



12. CHECK SRS WARNING LIGHT
(Click here)