Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEREO JACK ADAPTER ASSEMBLY

STEREO JACK ADAPTER ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Put protective tape around the No. 1 instrument cluster finish panel garnish.



  1. Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.


    B353454E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



3. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Open the instrument cluster finish panel lid.

  1. Put protective tape around the No. 2 instrument cluster finish panel garnish.



  1. Grip the No. 2 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 2 instrument cluster finish panel garnish.


    B246534E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



4. REMOVE HEATER CONTROL ASSEMBLY


    E202382
  1. Detach the 4 clips and remove the heater control assembly.



5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B353455
  1. Turn the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)


    B353456
  1. Turn the shift lever knob sub-assembly in the direction indicated by the arrow and remove it.



7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B245140E01
  1. Put protective tape around the upper console panel sub-assembly.
    Text in Illustration 
    *1
    Protective Tape



  1. Using a moulding remover, detach the 10 clips.


    B354447E01


    Text in Illustration 
    *A
    for VF2A
    *B
    for VF2BM, VF4BM
    *C
    for 2WD
    -
    -
    *1
    Protective Tape
    -
    -

  1. Disconnect each connector and remove the upper console panel sub-assembly.



8. REMOVE NO. 2 CONSOLE BOX RETAINER


    B239485
  1. Detach the clip, 2 claws and 2 guides to remove the No. 2 console box retainer.



9. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Climate Control Seat System)


    B353461
  1. Remove the 2 screws <B>.

  1. Detach the 4 clips.

  1. Disconnect 3 connectors and remove the lower center instrument cluster finish panel sub-assembly.



10. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Climate Control Seat System)


    B353460
  1. Remove the 2 screws <B>.

  1. Detach the 4 clips.

  1. Disconnect 2 connectors and remove the lower center instrument cluster finish panel sub-assembly.



11. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    B352337E01
  1. Detach the 2 claws to remove the No. 1 stereo jack adapter assembly.
    Text in Illustration 
    *A
    w/o Climate control seat system
    *B
    w/ Climate control seat system