ECM > INSTALLATION |
| 1. INSTALL NO. 2 ECM BRACKET |
Install the No. 2 ECM bracket with the 2 screws.
| 2. INSTALL ECM BRACKET |
Install the bracket with the 2 screws.
| 3. INSTALL ECM |
Install the ECM with the bolt and nut.
Connect the 6 connectors.
| 4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY |
Install the lower instrument panel (Click here).
| 5. PERFORM INITIALIZATION |
Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.
Turn the ignition switch to ON without operating the accelerator pedal.
Connect the Techstream to the DLC3 and clear the DTCs (Click here).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.