Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL TRANSMITTER (w/ Smart Key System)

DOOR CONTROL TRANSMITTER (w/ Smart Key System) > INSPECTION

for Preparation Click here



1. INSPECT TRANSMITTER BATTERY


  1. Inspect the operation of the transmitter.

    1. Remove the battery (lithium battery) from the transmitter .



    2. B180463
    3. Install a new or normal battery (lithium battery).

      HINT:
      If a new or normal battery is not available, first connect 2 new 1.5 V batteries in series. Then connect leads to the batteries and apply 3 V to the transmitter as shown in the illustration.

    4. From outside the vehicle, approximately 1 m (3.28 ft) away from the driver side outside door handle, test the transmitter by pointing its key plate at the vehicle and pressing a transmitter switch, or while carrying the transmitter, touch the inside of the handle and pull it.

      OK:
      The door lock can be operated via the transmitter.
      The LED comes on more than once.

      HINT:
      1. The operational area differs depending on the user, the way the transmitter is held, and the location.
      2. The weak electric waves from the transmitter may be affected if the area has strong electric waves or noise. The transmitter operational area may be reduced or the transmitter may not function.



    B180464
  1. Inspect the battery capacity.

    1. Remove the battery from an electrical key transmitter that does not operate (Click here).

    2. Attach a lead wire (0.6 mm (0.0236 in.) or less in diameter including wire sheath) with tape or equivalent to the negative terminal.

      NOTICE:
      Do not wrap the lead wire around a terminal, wedge it between terminals, or solder it. A terminal may be deformed or damaged, and the battery will not be able to be installed correctly.

    3. Carefully extend the lead wire from the position shown in the illustration and install the previously removed transmitter battery.



    4. B216218E03
    5. Using an oscilloscope, check the transmitter battery voltage waveform.

      HINT:
      When measuring the battery voltage, bring the electrical key transmitter within the smart key system operating range and operate the lock switch of a door handle to perform the measurement. For the smart key system operating range, refer to System Description (Click here).

      Standard Voltage:
      Tester Connection
      Tool Setting
      Condition
      Specified Condition
      Battery positive (+) - Battery negative (-)
      0.5 V/DIV., 100 ms/DIV.
      Engine switch off, all doors closed and lock switch touched
      2.2 to 3.2 V (Refer to waveform)

      If the result is not as specified, replace the transmitter battery.
      Text in Illustration 
      *a
      Measurement Position