DTC C1417 High Power Supply Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1417 | The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more. |
|
| 1.CHECK TERMINAL VOLTAGE (IG1) |
Disconnect the A6 skid control ECU connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A6-46 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid Control ECU) |
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||