Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
  1. Install the front bumper bracket sub-assembly LH with the 2 bolts.



2. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



3. INSTALL FRONT BUMPER SIDE SUPPORT LH
  1. Attach the 2 claws to install the front bumper side support LH.

  1. Install the screw and bolt.

    Torque:
    Bolt:
    5.4 N*m{ 55 kgf*cm , 49 in.*lbf }



4. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.



5. INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH
  1. Install the No. 2 front bumper extension sub-assembly LH with the 4 bolts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }



6. INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



7. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
  1. Install the front bumper reinforcement sub-assembly with the 6 nuts and screw.

    Torque:
    Nut:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }



8. INSTALL FRONT BUMPER ENERGY ABSORBER
  1. Install the front bumper energy absorber.



9. INSTALL RADIATOR SIDE DEFLECTOR LH
  1. Attach the 3 claws.

  1. Install the radiator side deflector LH with the clip.



10. INSTALL RADIATOR SIDE DEFLECTOR RH
  1. Attach the 3 claws.

  1. Install the radiator side deflector RH with the clip.



11. INSTALL FRONT BUMPER LOWER COVER
  1. Install the front lower bumper cover with the 5 bolts and clip.



12. INSTALL UPPER CENTER FRONT BUMPER RETAINER
  1. Install the upper front bumper retainer with the 3 bolts and 2 screws.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf } (for Bolt)



13. INSTALL FRONT BUMPER COVER
  1. Connect the 2 connectors.

  1. Attach the 14 claws to install the front bumper cover with radiator grille.

  1. Install the 3 bolts, 10 screws and 6 clips.



14. INSTALL UPPER RADIATOR SUPPORT SEAL
  1. Install the upper radiator support seal with the 13 clips.



15. ADJUST FOG LIGHT AIMING
(Click here)