Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER

COMBINATION METER > INSTALLATION

for Preparation Click here



1. INSTALL COMBINATION METER ASSEMBLY
  1. Connect the connectors.

  1. Install the combination meter with the 4 screws.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
  1. Attach the 7 claws to install the finish panel.

  1. Attach the 4 claws.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
  1. w/o Smart Key System:

    1. Connect the cooler thermistor.

    2. Attach the 4 clips to install the lower instrument panel finish panel assembly.

  1. w/ Smart Key System:

    1. Connect the connector and cooler thermistor.

    2. Attach the 4 clips to install the lower instrument panel finish panel assembly.



4. INSTALL NO. 2 SWITCH HOLE BASE
  1. Connect each connector.

  1. Attach the 6 clips and 2 guides to install the No. 2 switch hole base.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).