Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > INSTALLATION

for Preparation Click here



1. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel assembly and steering main shaft assembly.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



2. INSTALL CRUISE CONTROL MAIN SWITCH


    B237284
  1. Install the switch with the 2 screws.



    B239745
  1. Connect the connector.



3. INSTALL STEERING PAD SWITCH ASSEMBLY
  1. Attach the 2 claws and 4 guides to install the steering pad switch assembly.

  1. Install the 4 screws.

    Torque:
    2.4 N*m{ 24 kgf*cm , 21 in.*lbf }

  1. Connect the connector.



4. INSTALL STEERING PAD


    B238311
  1. Support the steering pad with one hand.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.

  1. Using a T30 "TORX" socket wrench, tighten the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



5. INSTALL NO. 2 STEERING WHEEL LOWER COVER


    B238308E01
  1. Attach the 2 claws to install the cover.
    Text in Illustration 
    *A
    w/o Cruise Control System
    *B
    w/ Cruise Control System



6. INSTALL NO. 3 STEERING WHEEL LOWER COVER
  1. Attach the 2 claws to install the cover.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT
(Click here)